本次偏差的根本原因是温湿度记录仪与打印机间的连接线插头内的一根电线与插

The root cause of this deviation is that a wire in the plug of the connection cable between the temperature and humidity recorder and the printer is welded to the plug when it leaves the factory, which causes accidental disconnection during use, causing the printer to disconnect. After preliminary investigation by the company's measurement personnel, the fault could not be rectified on site, so the temperature and humidity recorder and printer were removed and returned to the Y70 special maintenance room for Penam for inspection. Store room temperature and humidity for high-frequency recording (2 hours/time); install after maintenance, reprint 2021.03.01/00:00:00-2021.03.07/23:59:59 unsuccessful temperature and humidity curve. The intermediate temporary storage room is at room temperature, and the materials stored in it are stored at room temperature. The temperature and humidity recorder can record temperature and humidity normally, only the temperature and humidity curve cannot be printed normally, and the quality of the material will not be affected. The material can be reacted in the next step. No impact on product quality.

The root cause of this deviation is that a wire in the plug of the connecting line between the temperature and humidity recorder and the printer is falsely welded with the plug when leaving the factory, resulting in accidental disconnection during use, resulting in the disconnection of the printer. After the preliminary investigation by the company's metrology personnel, the failure could not be eliminated on site, so the temperature and humidity recorder and printer were removed and taken back to the special maintenance room of Peinan type in y70 building for inspection. During the inspection period (2021.03.08-2021.03.12), the room temperature and humidity of intermediate temporary storage were recorded in high frequency (2 hours / time); After the repair, the temperature and humidity curves of 2021.03.01/00:00-2021.03.07/23:59:59 were reprinted. The intermediate temporary storage room is at room temperature, and all the materials stored in it are stored at room temperature. The temperature and humidity recorder can record the temperature and humidity normally, but the temperature and humidity curve can not be printed normally, which will not affect the quality of materials. The materials can be reacted in the next step, which has no impact on the quality of products.<br>

The root cause of this deviation is that a wire in the connecting cable plug between the temperature and humidity recorder and the printer is welded with the plug when leaving the factory, resulting in accidental disconnection during use, resulting in disconnection of the printer. After preliminary investigation by the company's metrology personnel, the fault cannot be eliminated on site, so the temperature and humidity recorder and printer were removed and taken back to the special maintenance room of Peinan Class in Y70 Building for inspection. During the inspection period (March 8, 2021-March 12, 2021), the temporary room temperature humidity of the intermediate was recorded with high frequency (2 hours/time); After the repair, install and reprint the temperature and humidity curves that were not printed successfully from 2021.03.01/00: 00: 00-2021.03.07/23: 59: 59. The intermediate temporary storage room is at room temperature, and all the materials stored in it are stored at room temperature. The temperature and humidity recorder can record the temperature and humidity normally, but can not print the temperature and humidity curve normally, which will not affect the quality of materials. The materials can undergo the next reaction without affecting the quality of products.