注意：轴承规格、牌号的端面应装在可见部位，以便于更换3.9.4.1.4

Note: The end face of the bearing specification and brand should be installed in the visible part to facilitate the replacement of <br>3.9.4.1.4 mixer shaft sleeve and stuffing box installation; do not beat the shaft sleeve installation with a hand hammer, it needs to be heated to about 60º-70º with a cutting handle. Then use a copper rod to gently tap into the original disassembly position, and the size difference with the surrounding size of the stuffing box is 0.10mm

Note: the end face of bearing specification and brand shall be installed at the visible part for easy replacement<br>3.9.4.1.4 installation of mixer shaft sleeve and stuffing box; Do not knock the shaft sleeve with a hammer, but heat it to about 60 º - 70 º with a cutting handle, and then gently knock it into the original disassembly position with a copper rod. The size difference between it and the packing box is 0.10mm

Note: The end face of bearing specification and brand should be installed in the visible part to facilitate replacement. 3.9.4.1.4 Installation of shaft sleeve and stuffing box of mixer; Don't use a hammer to install the shaft sleeve, but heat it to 60-70 degrees with a cutting handle, and then tap it into the original disassembly position with a copper bar, and the size difference between the shaft sleeve and the packing box is 0.10mm