2：关于PE保护膜出现白点，我们要用专用粘合剂。这里的话，我们需注意，

2: For white spots on the PE protective film, we need to use special adhesives. Here, we need to pay attention that the surface tension of the composite special adhesive is very low. Furthermore, our coating and spreading effect on the surface of the glue layer is much higher than that of the general-purpose adhesive. <br> <br>This also means that if we use glue glue, it will be easy to control the leveling of the glue liquid, so that a more ideal coating state can be achieved. In this way, from the adhesive coating state, we can avoid white spots on the PE protective film by using electronic glue. <br> <br>3: With regard to the white spots on the PE protective film, there is one more thing we may need to pay attention to, that is, there is a certain matching relationship between the viscosity of the glue and the number of wire rollers. In layman's terms, even if the matching range is too large, the coating state of the glue will be destroyed. In this case, the phenomenon of white spots of the PE protective film will appear.

2: For PE protective film white spots, we have to use special adhesive. Here, we need to note that the surface tension of its composite special adhesive is very low, and we spread the surface of the glue layer much higher than the general adhesive.<br> <br>This also means that if we use glue, it will be easy to control the level of the glue, so that you can achieve a more ideal coating state. In this way, we can avoid white spots in pe protective film by using electronic glue in terms of adhesive coating alone.<br> <br>3: About the PE protective film white spot, there is one thing we may need to note, that is, the viscosity of the glue and the number of net line rollers actually exist a certain matching relationship. In layman's terms, it is too large beyond the matching interval, it will make the glue coating state destroyed, so we will also appear in the PE protection film white spot phenomenon.

2: As for the white spot of PE protective film, we need to use special adhesive. Here, we need to pay attention to the fact that the surface tension of the special composite adhesive is very low, and the spreading effect of our coating on the surface of the glue layer is much higher than that of the general adhesive.<br>This also shows that if we use glue, it will be easy to control the level of glue, so that we can achieve a more ideal coating state. In this way, from the adhesive coating state alone, we can use electronic glue to avoid white spots in PE protective film.<br>3: As for the occurrence of white spots in PE protective film, we may also need to pay attention to that there is a certain matching relationship between the viscosity of glue solution and the number of reticle roll lines. Generally speaking, if the matching range is too large, the coating state of the adhesive will be damaged. In this way, the phenomenon of white spots of PE protective film will appear.