重新设置X Y Z轴原点 在手轮模式下用手轮将Z轴慢慢移动到标记好的原

Reset the origin of the XYZ axis. In the handwheel mode, slowly move the Z axis to the marked origin position with the handwheel (the origin position is marked with yellow adhesive tape, there are two, move to the two adhesive tape positions in the same straight line It is the origin position, see Figure 9), reset the Z-axis origin in the system parameters (see Figure 10 for operation), and operate the XY axis as well (the XY origin position is also two yellow tapes on the same straight line, see Figure 11) The origin of the four axes can be set at will.

Reset X Y Z axis origin In hand wheel mode, slowly move the Z-axis to the marked origin position (the origin position is marked with yellow glue paper, there are two, move to two glue positions in the same straight line is the origin position, see Figure 9), reset the Z-axis origin in the system parameters (see Figure 10), XY-axis the same operation (XY origin position is also two yellow adhesive paper is located in the same straight line, see Figure 11) the fourth-axis origin can be set at will.

Reset the origin of X, y, Z axis In the handwheel mode, use the handwheel to slowly move the z-axis to the marked origin position (the origin position is marked with yellow adhesive tape, there are two, moving to the two adhesive tape positions, which are in the same straight line is the origin position, as shown in Figure 9). Reset the z-axis origin in the system parameters (see Fig. 10 for operation), and operate the XY axis similarly (the origin position of XY is also two yellow tapes on the same line) The origin of the fourth axis can be set at will.<br>