1. 软件启动后，若提示自检初始化失败并退出到窗口状态，请检查NI采集

1. After the software is started, if it prompts that the self-check initialization failed and exits to the window state, please check whether the NI capture card, cable, and ICT needle bed are connected in place and the needle bed power is turned on. <br>2. When the test terminates abnormally, it is necessary to clear the contents of the test serial number window, and then scan the serial number again for operation. <br>3. The test software version is subject to the latest release of Wenkong. The test items are selected according to the actual board conditions. The tool settings are operated by the factory's PE and TE, and irrelevant personnel are not allowed to operate at will. <br>4. Those who are bad in the first test need to be screened again, and those that are judged to be bad need to be placed in a red plate for isolation. <br>5. Since Boot can only be downloaded once, first piece verification must be done before order batch download.

1. After the software is started, if the self-test initialization is prompted to fail and exit to the window state, check that the NI acquisition card, cable, ICT needle bed is connected to the position, needle bed power is turned on.<br>2. When the test is terminated abnormally, the contents of the test serial number window need to be cleared and the serial number rescanned for operation.<br>3. The version of the test software is based on the latest release of the text control. According to the actual board situation to select test items, tool settings by the factory PE, TE operation, unrelated personnel may not operate at will.<br>4. The first test bad need to be re-screened, determined to be bad need to be placed in isolation on a red plate.<br>5. Since Boot can only be downloaded once, the first verification is required before the order can be downloaded in bulk.

1. After the software starts, if the self-test initialization fails and exits to the window state, please check whether the Ni acquisition card, cable and ICT needle bed are connected in place, and whether the needle bed power is on.<br>2. When the test is terminated abnormally, clear the window of test serial number, and then scan the serial number again for operation.<br>3. The test software version shall be subject to the latest distribution of document control. The test items are selected according to the actual board conditions. The tool settings are operated by PE and te of the factory, and irrelevant personnel are not allowed to operate at will.<br>4. If the test is not good for the first time, it should be screened again. If it is judged as bad, it should be placed in a red plate for isolation.<br>5. Since boot can only be downloaded once, it is necessary to verify the first article before batch downloading orders.