另外，我们在液压缸底部与折弯机滑块接触部位施加载荷。由于滑块垂直方向变

Further, we load is applied to the cylinder bottom and bending machine slide contact portion. Since the amount of deformation of the slider in the vertical direction is relatively small, it is a small elastic deformation. Therefore, the model is applied to the force receiving surface on the bottom of the slider uniform load. Bottom slide and the upper die is connected by a connecting piece to ensure uniform force transmitted to the slider upper mold.

In addition, we apply loads at the bottom of the hydraulic cylinder in contact with the bender slider. Because the vertical direction of the slider deformation is relatively small, is a small elastic deformation. Therefore, the model applies an average cloth load to the force face at the bottom of the slider. The bottom and upper molds of the slider are connected by the connecting block to ensure that the force is evenly transmitted from the slider to the upper mold.

In addition, we apply the load on the contact part between the bottom of the hydraulic cylinder and the slider of the bending machine. Due to the relatively small vertical deformation of the slider, it belongs to small elastic deformation. Therefore, a uniform load is applied to the stress surface at the bottom of the slider in the model. The bottom of the slider and the upper die are connected by the connecting block to ensure that the force is evenly transmitted from the slider to the upper die.<br>