其他厂家的切管机在切割最后一段材料的时候，由于前卡盘处于打开状态，仅由

When the pipe cutters of other manufacturers cut the last section of material, the front chuck is opened and fixed only by the rear chuck. The unfixed end sags due to the influence of gravity. At the same time, the processed pipe is in a rotating state, which will Seriously affect the cutting accuracy. This accuracy problem is particularly evident when cutting the pair of perforations and the 45-degree splice angle.

Other manufacturers of pipe cutting machine in the cutting of the last piece of material, because the front chuck is in an open state, only by the rear chuck fixed, there is no fixed end due to gravity influence sag, at the same time, the processed pipe in a rotating state, which will seriously affect the cutting accuracy. This accuracy problem is especially evident when cutting to perforation and 45-degree splicing angle.

When cutting the last section of material by pipe cutters of other manufacturers, because the front chuck is open, it is only fixed by the rear chuck, and the non fixed end sags due to gravity. At the same time, the processed pipe is in the rotating state, which will seriously affect the cutting accuracy. This kind of accuracy problem is especially obvious when cutting to perforation and 45 degree splicing angle.<br>