上辊在最高时，触摸屏上的上辊上位指示灯亮。然后，触摸屏在翻倒界面时，按

When the top roller, the upper roller on the touch screen indicator light. Then, after the touch screen interface from tipping over, press the front and rear support cylinders rise in place (i.e., the front and rear support cylinders on the touch screen when the upper limit is lit. press cylinder balancing decrease button. That is, when the pressing roller to the tail, the preload amount control about 4-5mm, not too much! could cause excessive bending of the tail roller, the roller and the other workpiece damage. bending overturning tip rack capable of freely compensating cylinder is set drop value. tipping frame can be turned .! overturned down the front frame (ie, outside of) non-stop people <br>remind: because of the bending machine chassis New grout anchor bolts yet, please immediately grouting cement mortar to be finished together after solidification, after tightening bolt before performing the procedure in accordance with the coiling machine tipping frame overturning / reset operation.

When the roll is at its highest, the upper roller upper indicator on the touch screen is on. Then, when the touch screen flips over the interface, press the front and rear support cylinder to rise to position (i.e. when the upper level of the front and rear support cylinder sits on the touch screen is on). Press the balance cylinder drop button again. That is, when pressing to the upper roller tail, the pre-pressure control is around 4-5mm, not too much! Otherwise, it will cause excessive bending of the upper roller tail, damage to the roller and other workpieces. The roller flips the frame to set the balance cylinder drop value with ease. The flip-flop can be overturned. The front of the overturned frame (i.e. the outside) is strictly forbidden to stand for the person!<br>Special reminder: Because the newly arrived roller chassis foot bolts have not yet grouted, please immediately grout. After the cement mortar is finished and solidified, after the screwing of the foot bolts, the roll-over/reset operation of the roll-over machine can be carried out in accordance with the prescribed procedures.

When the upper roll is at the highest position, the upper roll indicator light on the touch screen is on. Then, when the touch screen turns over the interface, press the front and rear support cylinders to rise to the position (that is, when the upper limit light of the front and rear support cylinders on the touch screen is on). Press down button of balance cylinder again. That is to say, when pressing to the tail of the upper roller, the preload should be controlled at about 4-5mm, not too much! Otherwise, the tail of the upper roller will be excessively bent and the upper roller and other workpieces will be damaged. The rolling machine can turn over the rack to set the falling value of balance cylinder. The tripod can be turned over. No one is allowed to stand in front of the overturning frame (i.e. outside)!<br>Special reminder: as the foundation bolts of the new plate rolling machine chassis have not been grouted, please immediately grout. After the cement mortar is completed and solidified, screw the anchor bolt, and then the roll over / reset operation of the roll over frame of the plate machine can be carried out according to the specified procedure.<br>