注意：轴承规格、牌号的端面应装在可见部位，以便于更换3.9.4.1.4

Note: The end face of the bearing specification and brand should be installed on the visible part to facilitate the replacement of <br>3.9.4.1.4 The mixer shaft sleeve and stuffing box installation. Do not beat the shaft sleeve installation with a hammer. It needs to be heated to about 60º-70º with a cutting handle. Then use a copper rod to gently tap into the original disassembly position, and the size difference with the surrounding size of the stuffing box is 0.10mm

Note: the end face of bearing specification and brand shall be installed at the visible part for easy replacement<br>3.9.4.1.4 for the installation of mixer shaft sleeve and stuffing box, do not knock the shaft sleeve with a hammer. Heat it to about 60 º - 70 º with a cutting handle, and then gently knock it into the original disassembly position with a copper rod. The size difference between the shaft sleeve and the stuffing box is 0.10mm

Note: The end face of bearing specification and brand should be installed in the visible part to facilitate replacement. 3.9.4.1.4 Install the shaft sleeve and stuffing box of mixer. Don't knock the shaft sleeve with a hammer, heat it to about 60-70 degrees with a cutting handle, and then tap it gently into the original disassembly position with a copper bar, and the size difference between the shaft sleeve and stuffing box is 0.10mm