施焊时，应在汽缸台板四角和中分面处架设百分表，并设专人监视台板四角的变

When welding, a dial indicator should be set up at the four corners and the middle surface of the cylinder platen, and special personnel should be assigned to monitor the deformation and displacement of the four corners of the platen. When the change is greater than 0.10mm, the welding shall be temporarily stopped, and the welding shall be continued after the normal state is restored. At the same time, the rotor lift change value shall be monitored. When the change reaches 0.02mm/m, the welding shall be temporarily stopped, and the full-time commander shall find out the reason. Weld again after the deformation is restored.

When welding, a percentage table should be set up at the four corners and the middle face of the cylinder bench plate, and a special person should be set up to monitor the deformation and displacement of the four corners of the table plate. When the change is greater than 0.10mm to temporarily stop welding, to restore normality before continuing welding, while monitoring the rota change value, when the change of 0.02mm/m, should temporarily stop welding, find a full-time commanding officer to find out the cause, wait for deformation to resume after welding.

During welding, dial indicator should be set up at the four corners and the split surface of the cylinder platen, and special personnel should be assigned to monitor the deformation and displacement of the four corners of the platen. When the change is greater than 0.10 mm, the welding shall be stopped temporarily, and the welding shall be continued after the normal state is restored. Meanwhile, the rotor lift change value shall be monitored. When the change reaches 0.02mm/m, the welding shall be stopped temporarily, and the full-time commander shall be asked to find out the cause, and then the welding shall be conducted after the deformation recovery.<br>