底脚定位、水平调试采用2-3人移动机器，将柜体搬到预定位置，地脚按相同

Foot positioning, horizontal debugging <br>using 2-3 mobile machine, the cabinet moved to a predetermined position, the foot in the same pre-set height, not be used during the door opened the door to pull the mobile device, in order to avoid deformation of the door. It is noted during handling security device provided at the safety of personnel; Principles positioned left to right or right to left (first side wall), roughly level with the measured level (phone software may be used), is inclined to avoid serious influence cabinet opening and subsequent installation; adjusting foot screws with a wrench to maintain a uniform height and alignment equipment. After commissioning level, check the door gap, fine-tuning of the front door when the upper and lower cases integrally linked to the foot, and the upper and lower door frame gap can not be less than 1mm. <br>Place Illustration:

Solefoot positioning, horizontal commissioning<br>The use of 2-3 people to move the machine, the cabinet body moved to a predetermined location, the foot according to the same height pre-adjusted, the process can not be opened after pulling the door to mobile device, so as not to deform the door. The handling process should pay attention to the safety of the equipment under the premise of ensuring the safety of personnel, positioning principle from left to right or right to left (first by the side of the wall), with the level (can use mobile phone software) to measure rough level, to avoid serious tilt of the cabinet affectthed the opening of the door and subsequent installation and commissioning, with a wrench to adjust the ground screws to maintain a unified height and alignment of the equipment. After the horizontal commissioning is completed, check the gap of the box door, the box door overall hanging situation when fine-tuning the front foot, the box door and the frame body of the upper and lower gap can not be less than 1mm.<br>Placement schematics:

Footing positioning and horizontal debugging<br>Use 2-3 people to move the machine, move the cabinet to a predetermined position, and pre adjust the foundation according to the same height. Do not pull the box door after opening the door to move the equipment, so as to avoid the deformation of the box door. During the handling process, the safety of the equipment shall be paid attention to on the premise of ensuring the safety of the personnel; the positioning principle is from left to right or from right to left (one side against the wall first), the level meter (mobile phone software can be used) shall be used to measure the rough level, so as to avoid the serious inclination of the cabinet affecting the door opening and subsequent installation and commissioning; the anchor screw shall be adjusted with a wrench to keep the equipment at a uniform height and alignment. After the completion of the horizontal commissioning, check the clearance between the box door. In case of the overall up and down hanging of the box door, fine tune the front foot. The clearance between the box door and the frame body shall not be less than 1mm.<br>Layout diagram:<br>