在实际加工中，还需要考虑一下因素的影响。对工件的曲率半径进行适当修正。

In actual processing, you also need to consider the influence of factors. Correct the radius of curvature of the workpiece appropriately. <br><br>Springback <br>Due to the elastic deformation, springback occurs after the sheet is rolled, and the radius of curvature will increase. Therefore, when rolling, we need to increase the down force and reduction. Because <br><br>work hardening <br>is cold plastic deformation, the strength and hardness of the plate will increase while the plasticity and toughness decrease. This requires increasing the pressing force and the amount of pressing. <br><br>For the yield limit of the sheet, <br>we take the ordinary rolling machine as an example. The working capacity of the bending machine is designed according to the yield limit of the plate as 235Mpa. If the material changes and the yield limit increases, the reduction force and reduction amount must be increased. <br>There are many factors that also affect the radius of curvature. We should make some corrections based on the actual situation. <br>Through the analysis and research of the pressing force and the amount of pressing, we can also control the actual rolling process. These provide references for worker operations and also provide theoretical basis for automatic control.

In the actual processing, we also need to consider the impact of factors. Appropriate correction shave radius of the workpiece.<br><br>Bounce back.<br>Due to the elastic deformation, the curvature radius increases after the plate roll is completed. Therefore, when rolling, we need to increase the down pressure and under pressure.<br><br>Processing hardens.<br>Because it is cold plastic deformation, so the plate will appear strength and hardness increaseand plasticity and toughness decreased phenomenon. This requires an increase in the pressure force and the underpressure.<br><br>The yield limit of the plate.<br>Let's take the ordinary roll board machine as an example. The working capacity of the coil machine is designed according to the plate yield limit of 235Mpa. If the material changes and the yield limit increases, increase the underpressure force and the underpressure amount.<br>There are many factors that can also affect the radius of curvature. We should make some amendments according to the actual situation.<br>Through the analysis and study of the pressure force and the pressure amount, we can also control the actual roll plate process. These provide reference for workers' operations, but also provide theoretical basis for automatic control.

In the actual processing, also need to consider the influence of the following factors. The curvature radius of the workpiece is corrected appropriately.<br>springback<br>Due to the existence of elastic deformation, springback occurs after the sheet is rolled and the radius of curvature will increase. Therefore, when rolling, we need to increase the down pressure and reduction.<br>Work hardening<br>Because of the cold plastic deformation, the strength and hardness of the plate increase while the plasticity and toughness decrease. This requires increasing the reduction force and amount.<br>Yield limit of plate<br>Let's take the ordinary bending machine as an example. The working capacity of the bending machine is designed according to the yield limit of 235mpa. If the material changes and the yield limit increases, the reduction force and reduction amount should be increased.<br>There are also many factors that affect the radius of curvature. We should make some amendments according to the actual situation.<br>Through the analysis and research of screwdown force and reduction amount, we can also control the actual rolling process. These provide a reference for workers to operate, but also provide a theoretical basis for automatic control.<br>