按照《预冲式冲管注射器吸塑包装标准操作规程》进行操作，选取目前有效的工

Operate in accordance with the "Standard Operating Procedures for Pre-flushing Syringe Blister Packaging", select the maximum, minimum and intermediate values ​​of the current valid process parameter range, and each group of parameters is used as a test group for sample testing. First set the selected parameters, preheat the equipment to the target temperature, maintain it for 5-10 minutes until the temperature is completely stable, and then perform the film forming test. During the test, the technical department will record the test data, and the quality department will sample and inspect the appearance of the blister for each group of test samples, and fill in the attached table 2 "Blister Packaging Process Verification-Blister Preform Appearance Inspection Record", Attached Table 3 "Blister Packaging Process Verification-Blister Forming Appearance Inspection Record".

In accordance with the "pre-flush punch syringe ptister packaging standard operating procedures", select the current effective process parameter range of the maximum, minimum and median three sets of parameters, each set of parameters as a test group, sample test. First set the selected parameters, warm up the device to the target temperature, maintain 5-10 minutes until the temperature is completely stable, and then carry out the next membrane molding test. During the test process by the technical department to do test data records, the quality department to sample and each set of test samples for the appearance of the bubble cover inspection, and fill in the schedule two "blister packaging process verification - bubble pre-molded appearance inspection record", schedule three "blister packaging process verification - bubble molding appearance inspection record."

According to the "standard operating procedures for blister packaging of pre impact flushing syringe", three groups of parameters including maximum, minimum and intermediate value in the range of effective process parameters are selected, and each group of parameters is taken as a test group for sample test. First, set the selected parameters, preheat the equipment to the target temperature, maintain for 5-10 minutes until the temperature is completely stable, and then conduct the molding test of the film. During the test, the technical department shall record the test data, the quality department shall take samples and inspect the appearance of blister for each group of test samples, and fill in the attached table 2 "blister packaging process verification - blister preform appearance inspection record", and Annex 3 "blister packaging process verification - blister forming appearance inspection record".<br>